Introduction
-
-
Open your STL file in the Ultimaker Cura
-
Set scaling (ex. half size) , position (on the printer), support settings (support you print), raft settings (makes it easier to print and remove print), fill settings (thickness of the walls) See video for more info
-
Insert an SD card into your computer and export your .gcode to your SD card
-
Note: You cannot use this .gcode file for any other 3D printers
-
-
-
Enter SD card into slot. Then turn Ultimaker on.
-
If tape on baseplate is broken or damaged replace the tape. Make sure that the tape is level.
-
Using the menu navigate to Print --> yourFileName
-
-
-
Make sure that your printer filament is the color you want.
-
To change the color of the filament follow the steps in Material --> Change
-
-
-
The Makerbot will present a complete screen
-
After, carefully remove print with a spatula
-
Replace tape on baseplate if needed
-