-
-
Consider wearing a mask. While non-toxic, some fumes are unpleasant to inhale. Consider wearing tinted safety glasses (sunglasses okay); looking at laser cutting can be bad for eyes.
-
Make sure you're cutting appropriate material! If you're not sure, check the MSDS or ask another student.
-
-
-
Turn on water chiller
-
Turn on Laser Cutter using Key
-
Connect using ethernet to designated laptop
-
-
-
Open RetinaEngrave on the Dell
-
Open file-to-be lazed. File -> Print to FullSpectrum RetinaEngrave Driver.
-
Set Raster Settings, Vector Settings. Refer to video on how to do this.
-
-
-
Place material to be cut on bed
-
Use the plastic tool to align vertical (z) height of bed
-
Use x/y functions on RetinaEngrave to move laser head to proper start point
-
Run perimeter to make sure the cut will be clean.
-
Cancel: I did not complete this guide.
One other person completed this guide.